
FT100 Series Installation & Operation Manual
www.ot-systems.com 5
(2) Product Overview
2.1 Introduction
The FTD100 Series products comprise of either single-mode or multi-mode fiber optic
transmitters and receivers for the optical transmission of ONE forward (Tx → Rx) video signal on
one fiber. The products work at wavelengths of 1310nm or 1550nm with either a 9/125um or
62.5/125um fiber for single-mode or multi-mode transmission respectively.
A non-compressed 8-bit digital video transmission scheme is implemented which supports
video in NTSC, PAL and SECAM formats.
For single-mode transmission, we also offer specifically designed products for long-haul
transmissions up to 60km. These models include the letter “L” in the suffix, e.g. FTD100-SSTL for
Tx, FTD100-SSRL for Rx, etc.
The FTD100 Series units are also available as plug-in card modules installed in a 19”
rack-mount chassis. Each plug-in card occupies one slot in the rack-mount chassis. The rack
mount chassis has to be ordered separately, and comes with its own power supply for powering
the installed card modules.
2.2 Models selection table
Installation
requirements
Single-mode 1-Ch Video Transmitter
Card Module
Housed in
FT-C18
chassis
2
FT-C18
chassis has
to be
ordered
separately
Single-mode Long-haul 1-Ch Video
Transmitter Card Module
Single-mode 1-Ch Video Receiver
Card Module
Single-mode Long-haul 1-Ch Video
Receiver Card Module
Multi-mode 1-Ch Video Transmitter
Card Module
Multi-mode 1-Ch Video Receiver
Card Module
1
If the optical connector is FC type, the suffix in the model number will be “-FXX”. Eg. FTD100-FST
2
Refer to FT-C18 product manual for specifications
Komentáře k této Příručce